RECREATIONAL CRAB POT REQUIREMENTS
Maryland Department of Natural Resources (DNR) enacted a regulation effective April 1, 1999 which requires all recreational waterfront property owners who set crab pots attached by rope, line or pole in front of their property or privately owned pier or dock to attach a Crab Pot Bycatch Reduction Device (CPBRD) to each funnel or entrance to the lower chamber of the crab pot. This action was taken as a conservation effort to prevent air-breathing animals (turtles and muskrats) from entering and drowning in crab pots.
The following link takes you away from the Maryland DNR web site: How to make your crab pot turtle-safe
MAKING THE PART YOU NEED. . .
BELOW ARE TWO METHODS (FIGURE #2) FOR MAKING THE CPBRD
Galvanized wire (suggested eleven (11) gauge) or plastic
SIZE: Height 1 3/4" x Length 4 3/4"
1a. Start with 15" of wire or plastic (Figure #1) leaving approximately 1/2" piece of wire or plastic before making first bend
2a. Measure 1 3/4" from first bend and bend to form a rectangle
3a. Measure length of wire or plastic 4 3/4" make next bend
4a. Measure 1 3/4" for the second side, bend
5a. End your rectangular CPBRD extending the wire or plastic approximately 1/2" past bend (1a) to form a hook (Figure #2, A)
6a. Bend or loop overlap to secure
1b. Starting with a 16" piece of wire or plastic, measure 1" piece of wire or plastic before making first bend and follow Figure #1 instructions for making a rectangular CPBRD (steps 2a, 3a, and 4a)
2b. After making the final bend leave an overlap of approximately 1"
3b. The 1" overlaps can be bent along the height and length side and secured by hog rings or plastic ties
Firmly attach a rectangular CPBRD to every entrance or funnel in the lower crab pot chamber. Secure the CPBRD with hog rings or by bending or crimping the crab trap wire around the CPBRD. (See Figure #3)
|Placement to the back of opening|